Power Window Auto Operation Initialization

POWER WINDOW AUTO OPERATION INITIALIZATION
1. Turn the ignition switch ON.
2. Open the window all the way DOWN.
3. Pull all the way UP on the switch and hold (close the window).
- Continue holding the switch all the way UP for 4 seconds after the window is closed.

4. Confirm the window is now operating correctly.

NOTE:
- If the window is still not operating correctly, refer to GW-29, "Trouble Diagnosis Symptom Chart". Symptom Related Diagnostic Procedures
- The above initialization procedure must be performed if any of the following occur:
- Battery cable is disconnected
- Power window switch connector is disconnected
- Power window regulator is replaced
- Power window motor is replaced
- Window glass is removed
- Window glass run rubber is replaced
- Power window fuse is blown
- Window is partly opened and/or closed many times without being fully closed.