Removal and Replacement

FRONT DOOR GLASS AND REGULATOR

Removal and Installation






DOOR GLASS

Removal
1. Remove the front door finisher.
2. Disconnect the front door speaker electrical connector.
3. Position aside the sealing screen.

NOTE: If sealing the screen is reused, cut the butyl-tape so that a part of butyl-tape remains on the sealing screen.




4. If equipped, reconnect the power window switch electrical connector. Operate the power window main switch to raise/lower the door window until the glass bolts can be seen.
5. Remove the door glass bolts.




6. While holding the door window, raise it at the rear end to pull the glass out of the sash toward the outside of the door.




7. Remove the lower sash (rear) bolt, move the lower end portion ahead of the door panel (3) and pull out the insertion (2) of the upper end from the door panel to remove the lower sash (rear)(1).
8. Remove the lower sash (front) bolt and pull out the lower sash (front) just downward to remove it.
9. Remove the door glass run from the door panel. Installation Installation is in the reverse order of removal.

Installation
Installation is in the reverse order of removal.

REGULATOR ASSEMBLY

Removal
1. Remove the front door finisher.
2. Disconnect the harness connector of front speaker, and then remove sealing screen.

NOTE: If sealing screen is reused, cut the butyl-tape so that a part of butyl-tape remains on the sealing screen.




3. If equipped, reconnect the power window switch electrical connector. Operate the power window main switch to raise/lower the door window until the door glass bolts can be seen.
4. Remove the door glass bolts.




5. Raise the door glass and hold with a suction lifter A.
6. If equipped, disconnect the harness connector from the regulator assembly.




7. Remove the door glass bolts, and then remove the regulator assembly.

Installation
Installation is in the reverse order of removal.

Inspection after Removal




Check the regulator assembly for the following. [If a problem is detected, grease or replace it as shown].
- Wire wear
- Regulator deformation
- Grease condition for each sliding part