Removal And Installation

REAR BUMPER WITH AERODYNAMIC DIFFUSER


Removal and Installation


CAUTION:
Rear bumper fascia is made of resin. Do not apply strong force to it, and be careful to prevent contact with oil.

REMOVAL
1. Fully open the back door.
2. Remove the rear combination lamp finisher (RH) and the rear combination lamp finisher (LH) and the rear combination lamp (RH) and the rear combination lamp (LH).
3. Remove the rear bumper fascia bottom bolts and clips.
4. Remove the tapping screws from the left and right of the rear bumper fascia.
5. Remove the clips from the bottom of the rear bumper fascia.
6. Remove the clips and connector of license lamp assembly from the left and right of the rear bumper fascia, and remove the rear bumper fascia assembly.

CAUTION:
- Two people shall perform the work to remove the Rear bumper fascia assembly that it is not dropped.

INSTALLATION
Install in the reverse order of removal.
- Check the clearance when installing the Rear bumper fascia assembly.