Without 7 Inch Display

INTAKE SENSOR


Removal and Installation


REMOVAL
1. Remove high-pressure evaporator pipe and low-pressure evaporator pipe. Refer to Exploded View.
2. Disconnect intake sensor connector.





3. Slide evaporator (1) toward the right side of the vehicle (as shown in the figure), and then remove intake sensor (2).

INSTALLATION
Installation is basically the reverse order of removal.

CAUTION:
- Replace O-rings with new ones. Then apply the compressor oil to them when installing.
- Mark the mounting position of intake sensor bracket prior to removal so that the reinstalled sensor can be located in the same position.
- Never rotate the bracket insertion part when removing and installing the intake sensor.
- Check for leakages when recharging refrigerant. Refer to Leak Test.