Removal And Installation

REAR COMBINATION LAMP


Removal and Installation


CAUTION:
Disconnect the battery negative terminal or remove the fuse.

REMOVAL
1. Remove the rear combination lamp finisher.
2. Remove the luggage side finisher upper. Refer to Exploded View.
3. Remove the rear combination lamp mounting nut and bolts.
4. Pull the rear combination lamp toward rear of the vehicle.
5. Disconnect the rear combination lamp connector.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
Always replace EPT sealer and seal packing with a new one, if rear combination lamp assembly is reused.

Installation EPT sealer
1. Remove the EPT sealer from rear combination lamp assembly.





2. Apply new EPT sealer within mark off line (A) surface while following the mark off line (B) as shown in the figure.