Special Repair Requirement

INSPECTION AND ADJUSTMENT


M/T NEUTRAL POSITION LEARNING : Special Repair Requirement

1.START
Do you have CONSULT-III?
Do you have CONSULT-III?
YES - GO TO 2.
NO - GO TO 3.
2.PERFORM M/T NEUTRAL POSITION LEARNING
With CONSULT-III
1. Check that there is no sticking when shifting shift lever to the neutral position.
2. Turn ignition switch ON.
3. Select "M/T NEUTRAL POS LEARN" in "WORK SUPPORT" mode with CONSULT-III.
4. Touch "Start" and wait a few seconds.

NOTE:
Never touch shift lever. Otherwise learning may not complete normally.
5. Make sure the "COMPLETE" is displayed on CONSULT-III screen.

NOTE:
If "INCMP" is displayed, return to step 1 and repeat the procedures again.
- END
3.PERFORM M/T NEUTRAL POSITION LEARNING
Without CONSULT-III

NOTE:
- It is better to count the time accurately with a clock.
- It is impossible to switch the learning mode when a clutch interlock switch circuit has a malfunction.
1. Check that there is no sticking when shifting shift lever to the neutral position.
2. Turn ignition switch ON and wait 5 seconds.
3. Within 5 seconds repeat the following operation 3 times. Fully depress and fully release clutch pedal while pressing and holding S-MODE switch.
4. Wait 3 seconds while S-MODE switch is released.
5. Wait 5 seconds while pressing S-MODE switch.
6. Wait 3 seconds while S-MODE switch is released.
7. Within 5 seconds repeat the following operation 5 times. Fully depress and fully release clutch pedal while pressing and holding S-MODE switch.
ECM starts M/T Neutral Position Learning.

NOTE:
Never touch shift lever. Otherwise learning may not complete normally.





8. Shift position indicator on combination meter blinks for 5 seconds when the leaning is complete.

NOTE:
If shift position indicator does not blink or blinks continuously, return to step 1 and repeat the procedures again.
- END