Removal And Installation

BACK-UP LAMP SWITCH


Removal and Installation


REMOVAL
1. Disconnect the battery cable from the negative terminal.





White arrow indicates Vehicle Front

2. Disconnect clip (A) from bracket (1).
3. Remove bracket from rear extension.
4. Disconnect back-up lamp switch connector.





White arrow indicates Vehicle Front

5. Remove back-up lamp switch from rear extension.

INSTALLATION





1. Temporarily tighten back-up lamp switch onto rear extension by rotating once or twice.


CAUTION:
Remove old sealant and oil adhering to threads.
2. Apply recommended sealant to threads of back-up lamp switch as shown in the figure.
- Use Genuine Silicone RTV or an equivalent. Refer to Recommended Chemical Products and Sealants.





White arrow indicates Vehicle Front

3. Tighten back-up lamp switch to the specified torque.

4. For the next step and after, install in the reverse order of removal.