System Specifications

CYLINDER HEAD






Cylinder Head Torque and Sequence

Disassembly and Assembly

Intake Manifold Collector

Intake Manifold Collector Bolt 10.8 Nm (1.1 kg.m 8 ft. lb.)





Arrow indicates Engine front


INTAKE MANIFOLD

- If stud bolts were removed, install them and tighten to the torque specified below.

Torque 10.8 N.m (1.1 kg-m, 8 ft-lb)




- Tighten all mounting bolts to the specified torque in two or more steps in numerical order as shown in the figure.

Arrow Indicates Engine Front.

CAUTION: Install intake manifold with the marks (put on the intake manifold and the cylinder head before removal) aligned.






Camshaft Sprocket









Exhaust Manifold










Install exhaust manifold and tighten mounting nuts in numerical order as shown in the figure.

A : Bank 1
B : Bank 2
Arrow Indicates Engine front.

NOTE: Tighten nuts the No. 1 and 2 in two steps. The numerical order No. 7 and 8 shows the second step.


Cam Bearing Cap






- Tighten mounting bolts in the following step, in numerical order as shown in the figure.

A : Bank 1
B : Bank 2
Arrow indicates Engine front


i. Tighten bolts in numerical order as shown.

Torque: 1.96 N-m (0.20 kg-m, 1 ft-lb)

ii. Tighten bolts in numerical order as shown.

Torque: 5.88 N-m (0.60 kg-m, 4 ft-lb)

iii. Tighten bolts in numerical order as shown.

Torque: 10.4 N-m (1.1 kg-m, 8 ft-lb)