Torque and Sequence

INTAKE MANIFOLD

- If stud bolts were removed, install them and tighten to the torque specified below.

Torque 10.8 N.m (1.1 kg-m, 8 ft-lb)




- Tighten all mounting bolts to the specified torque in two or more steps in numerical order as shown in the figure.

Arrow Indicates Engine Front.

CAUTION: Install intake manifold with the marks (put on the intake manifold and the cylinder head before removal) aligned.






Intake Manifold Collector

Intake Manifold Collector Bolt 10.8 Nm (1.1 kg.m 8 ft. lb.)





Arrow indicates Engine front

ELECTRIC THROTTLE CONTROL ACTUATOR (BANK 1 AND BANK 2)
- Tighten in numerical order as shown in the figure.









NOTE:
- The figure shows the electric throttle control actuator (bank 1) viewed from the air duct side.
- Viewed from the air duct side, the order of tightening mounting bolts of electric throttle control actuator (bank 2) is the same as that of the electric throttle control actuator (bank 1).