Removal And Installation

FRONT OIL SEAL


Removal and Installation


REMOVAL
1. Drain gear oil. Refer to Draining.
2. Remove transmission assembly. Refer to Removal And Installation (Without S-MODE) or Removal And Installation (With S-MODE).





3. Remove mounting bolts ( Black arrow indicates) and sealing bolts (1).
4. Remove front cover and front cover gasket from transmission case.





5. Remove front oil seal from front cover using a flat-bladed screwdriver.

CAUTION:
Never damage front cover.

INSTALLATION
1. Install front oil seal (1) to front cover using the drift (A) [SST: KV38102100 (J-25803-01)].






Dimension "H" : 8.55 - 9.55 mm (0.3366 - 0.3760 in)


CAUTION:
Never incline front oil seal.
2. Install front cover gasket and front cover to transmission case.

CAUTION:
- Never reuse front cover gasket.
- Never damage front oil seal.
- Remove any moisture, oil, or foreign material adhering to both mating surfaces.





3. Temporarily tighten mounting bolt ( Black arrow indicates ) and sealing bolt (1).





4. Temporarily tighten mounting bolts ( Black arrow indicates ) and sealing bolts (1).





5. Tighten mounting bolts ( Black arrow indicates ) and sealing bolts (1) to the specified torque in the numerical order as shown in the figure.
6. Install transmission assembly. Refer to Removal And Installation (Without S-MODE) or Removal And Installation (With S-MODE).
7. Refill gear oil. Refer to Refilling.