BCM (Body Control Module)

BCM (BODY CONTROL MODULE)


Removal and Installation


REMOVAL

CAUTION:
Before replacing BCM, perform "READ CONFIGURATION" to save or print current vehicle specification. Refer to Description.
1. Disconnect the 12-volt battery negative terminal.
2. Remove the combination meter. Refer to Removal and Replacement.





3. Remove the BCM screws (A), and pull out the BCM (1).
4. Disconnect the BCM connector and remove the BCM (1).

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:
- When replacing BCM, perform "WRITE CONFIGURATION". Refer to Description Special Repair Requirement.
- When replacing BCM, perform the system initialization (NATS). Refer to the CONSULT-III operation manual for the initialization procedure.
- When replacing BCM, if new BCM does not come with keyfobs attached, all existing keyfobs must be re-registered. Refer to the CONSULT-III operation manual for the initialization procedure.