Mode 1

INSPECTION MODE


MODE 1

MODE 1 : Diagnosis Description


DESCRIPTION
This vehicle will perform the engine idling stop when the engine is warmed up and SOC is in good condition. If engine running with vehicle stopped is necessary for service, the vehicle should be set in the inspection mode.
And if the vehicle is necessary to be set on a chassis-dynamometer, also the vehicle should be set in the inspection mode.
2 types of inspection mode are available.






ACTIVATING PROCEDURE

CAUTION:
Driving the vehicle without deactivating the inspection mode may damage the hybrid transaxle.

NOTE:
- The idling speed in inspection mode is approximately 1,000 rpm. The engine speed increases to 1,500 rpm if the accelerator pedal is depressed by less than 60% with P range. If the accelerator pedal is depressed by more than 60%, the engine speed increases to 2,500 rpm.
- If a DTC is set during the inspection mode, the hybrid system warning light will stop blinking and illuminate continuously.
- When the hybrid system warning light illuminates during the inspection mode, deactivate the inspection mode and check DTC.

With CONSULT-III
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Shift the selector lever to P position.
3. Turn ignition switch ON.
4. Select "INSPECTION MODE 1" in "ACTIVE TEST" mode with CONSULT-III.
5. Check that hybrid system warning light is blinking in the combination meter.
6. Turn ignition switch ON (READY), then the engine will start.

Without CONSULT-III
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Shift the selector lever to P position.
3. Turn ignition switch ON and perform the following steps 5 to 9 within 60 seconds.
4. Repeat the following procedure 2 times.
- Fully depress the accelerator pedal.
- Fully release the accelerator pedal.
5. Shift the selector lever to N position.
6. Repeat the following procedure 2 times.
- Fully depress the accelerator pedal.
- Fully release the accelerator pedal.
7. Shift the selector lever to P position.
8. Repeat the following procedure 2 times.
- Fully depress the accelerator pedal.
- Fully release the accelerator pedal.
9. Check that hybrid system warning light is blinking in the combination meter.
If not blinking, perform steps 1 to 9 again.
10. Turn ignition switch ON (READY), then the engine will start.

DEACTIVATING PROCEDURE

CAUTION:
Driving the vehicle without deactivating the inspection mode may damage the hybrid transaxle.

With CONSULT-III
1. Touch "BACK" on the "CONSULT-III" screen to cancel the "ACTIVE TEST".
2. Turn ignition switch OFF. The HV main system turns off simultaneously.

Without CONSULT-III
1. Turn ignition switch OFF. The HV main system turns off simultaneously.