Low Tire Pressure Warning Lamp Blinks

LOW TIRE PRESSURE WARNING LAMP BLINKS


Low Tire Pressure Warning Lamp Flashes When Ignition Switch Is Turned On


NOTE:
If low tire pressure warning lamp flashes as shown, the system is normal.
Flash Mode A





- This mode shows transmitter status is OFF-mode.
Carry out transmitter wake up operation. Refer to Transmitter Wake Up Operation.
DIAGNOSTIC PROCEDURE
1.CHECK BCM CONNECTORS
1. Turn ignition switch OFF.
2. Disconnect BCM harness connectors.
3. Check terminals for damage or loose connections.
Is the inspection result normal?
YES - GO TO 2
NO - Repair or replace damaged parts.
2.CHECK TIRE PRESSURE WARNING CHECK CONNECTOR CIRCUIT
Check continuity between BCM harness connector M18 terminal 57 and ground.






Continuity should not exist.

Is the inspection result normal?
YES - Replace BCM. Refer to BCM (Body Control Module).
NO - Repair circuit for short to ground.