Power Distribution System

BCM (BODY CONTROL MODULE)


Removal and Installation


REMOVAL
1. Remove the combination meter. Refer to Removal and Replacement.





2. Remove the BCM screws (A), and pull out the BCM (1).
3. Disconnect the BCM connector and remove the BCM (1).

INSTALLATION
Installation is the reverse order of removal.

NOTE:
- When replacing BCM, it must be configured. Refer to the CONSULT-III operation manual for the initialization procedure.
- When replacing BCM, perform initialization of the NATS system and registration of all the intelligent ignition key IDs. Refer to the CONSULT-III operation manual for the initialization procedure.
- When replacing BCM, if new BCM does not come with keyfobs attached, all existing keyfobs must be re-registered.