Lock-Up Is Not Released

TROUBLE DIAGNOSIS FOR SYMPTOMS


Lock-up Is Not Released


SYMPTOM:
Lock-up is not released when accelerator pedal is released on "Cruise Test -- Part 1".

DIAGNOSTIC PROCEDURE
1. CHECK SELF-DIAGNOSTIC RESULTS
Perform self-diagnosis. Refer to CONSULT-III Function (A/T) or Diagnosis Procedure Without CONSULT-III .
Is any malfunction detected by self-diagnostic results?
YES >> Check the malfunctioning system. Refer to CONSULT-III Function (A/T) or Diagnosis Procedure Without CONSULT-III .
NO >> GO TO 2.
2.CHECK SYMPTOM
Check again. Refer to Cruise Test - Part 1 .
OK or NG
OK >> INSPECTION END
NG >> GO TO 3.
3.CHECK TCM
1. Check TCM input/output signals. Refer to Pinout Values and Diagnostic Parameters .
2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK >> INSPECTION END
NG >> Repair or replace damaged parts.