Rear Suspension

COIL SPRING


Removal and Installation


REMOVAL
1. Remove wheel and tire using power tool.
2. Remove wheel sensor from wheel hub and bearing assembly. Refer to Service and Repair.

CAUTION:
Do not pull on wheel sensor harness.
3. Separate brake tube from wheel cylinder. Refer to Rear.
4. Set jack under rear suspension beam.





5. Remove shock absorber lower side bolt. Refer to Removal and Replacement.
6. Gradually lower the jack, and then remove coil spring and rear spring rubber seat (upper and lower).

INSPECTION AFTER REMOVAL
Check coil spring and spring rubber seat for deformation, cracks, and damage, and replace it if a malfunction is detected.

INSTALLATION
Installation is in the reverse order of removal.
- For tightening torque, refer to Rear Suspension.
- Tighten wheel nuts to specification. Refer to Rotation.





- When installing spring, be sure to securely install the spring end position aligned to flush of rear spring rubber seat (lower) as shown.