Engine Controls - DTC P0011 Stored In ECM
Classification: EC10-009AReference: NTB10-058A
Date: June 25, 2010
2009 CUBE AND VERSA; DTC P0011
This bulletin has been amended. Notes were added to Step 3. No other changes have been made. Discard all previous copies.
APPLIED VEHICLE:
2009 cube (Z12)
2009 Versa (C11) Sedan and Hatchback
APPLIED ENGINE MR18DE only
IF YOU CONFIRM:
DTC P0011 (IVT Control) is stored
AND
There are no drivability symptoms.
ACTIONS:
1. Refer to Step 2 in the Service Procedure to confirm this bulletin applies to the vehicle you are working on.
2. If this bulletin applies, reprogram the ECM.
NOTE:
If there are drivability symptoms, this bulletin may not apply. Resolve drivability symptoms first, and then recheck for DTC P0011.
CLAIMS INFORMATION
IMPORTANT:
The purpose of ACTIONS (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair.
SERVICE PROCEDURE
NOTE:
If there are drivability symptoms this bulletin may not apply. Resolve drivability symptoms first, and then recheck for DTC P0011.
1. Connect C-III to the vehicle to begin the reprogramming procedure.
CAUTION
2. When you get to the ECM Reprogramming screen shown in Figure 1, confirm this bulletin applies as follows.
A. On your C-III screen, look at the Part Number column (see Figure 1):
^ If this column is blank (no part number listed), this bulletin does not apply. Close C-III and refer to ASIST for further diagnostic information.
^ If a Part Number is listed, write it on the Repair Order.
B. Compare the Part Number you wrote down to the numbers in the Current ECM Part Number column in Table A.
^ If there is a match, this bulletin applies. Continue with the reprogramming procedure.
NOTE:
If there are two lines (two reprogramming options) on your C-III screen, use the one that does not have the message "Caution! Use ONLY with NTBXX-XXX".
^ If there is not a match, this bulletin does not apply. Close C-III and refer to ASIST for further diagnostic information.
3. If this bulletin applies and you have performed ECM reprogramming, the screen in Figure 2 appears when reprogramming is complete.
4. Make sure to erase DTCs from all systems.
NOTE:
During reprogramming, DTCs will set in several systems and must be erased.
5. Test drive the vehicle and make sure it operates correctly and the Check Engine light is OFF.
^ If the Check Engine light comes ON, go back to ASIST for further diagnostic information. Refer to the applicable Electronic Service Manual as needed.
^ Diagnosis and repairs beyond ECM reprogramming are not covered by this bulletin.