Turbine Revolution Sensor (Power Train Revolution Sensor)

ON-VEHICLE SERVICE


Turbine Revolution Sensor (Power Train Revolution Sensor)


COMPONENTS






REMOVAL AND INSTALLATION

Removal
1. Disconnect the battery negative terminal.
2. Remove air duct (inlet). Refer to Service and Repair Service and Repair.





3. Disconnect turbine revolution sensor (power train revolution sensor) harness connector (1).
4. Remove turbine revolution sensor (power train revolution sensor) bolt.
: Bolt
5. Remove turbine revolution sensor (power train revolution sensor) (2) from A/T.
6. Remove O-ring from turbine revolution sensor (power train revolution sensor) (2).

Installation
Installation is in the reverse order of removal.

CAUTION:
- Do not reuse O-ring.
- Apply ATF to O-ring.