B1775

B1775 STORAGE LID STATUS SENSOR (RH)





DTC Logic

DTC DETECTION LOGIC

NOTE:
If two or more DTCs are detected, RF, and determine trouble diagnosis order.






DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Start engine.
2. Operate soft top to fully open and fully close.
3. Select "Self Diagnostic Result" mode of "CONVERTIBLE ROOF" using CONSULT-III.
4. Check DTC.
Is DTC detected?
YES - Go to B1775.
NO - INSPECTION END




Diagnosis Procedure
1.CHECK STRAGE LID STATUS SENSOR RH CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect and strage lid status sensor and soft top control unit harness connector.
3. Check the continuity between strage lid status sensor RH harness connector and soft top control unit harness connector.





4. Also check harness for short to ground and short to power.
Is the inspection result normal?
YES - GO TO 2.
NO - Repair open circuit, short to ground or short to power in harness or connectors.
2.REPLACE HYDRAULIC UNIT
Replace hydraulic unit. Removal And Installation.
Is the inspection result normal?
YES - INSPECTION END
NO - GO TO 3.
3.REPLACE SOFT TOP CONTROL UNIT
Replace soft top control unit. Removal And Installation.
Is the inspection result normal?
YES - INSPECTION END
NO - GO TO 4.
4.CHECK INTERMITTENT INCIDENT
Intermittent Incident.
- INSPECTION END