Disassembly And Assembly

FRONT BUMPER ASSEMBLY


Disassembly and Assembly









[Nismo 370Z]


REMOVAL
1. Remove the NISSAN emblem.
2. Remove the rivets from the left and right of the front bumper fascia and then remove the front bumper protector (RH, UPR) and the front bumper protector (LH, UPR) and the front bumper protector (RH, LWR) and the front bumper protector (LH, LWR).
3. Remove the Screws from the bottom of the front bumper fascia and then remove the lower front bumper fascia.
4. Remove the rivets from the left and right of the front bumper fascia and then remove the front bumper bracket.
5. Remove the front bumper spacer (the sponge tape) from the back side of front bumper fascia.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- The sponge tape cannot be reused. Replace it with new tape.
- Remove the oil and grease from the attachment surface and clean it.
1. Attach the front bumper spacer (the sponge tape) along the mark-off line on the underside of the front bumper fascia.





2. Use the rivets to fasten the front bumper bracket on the left and right of the front bumper fascia.
3. Fasten the lower front bumper fascia with screws.





4. Press the front bumper protector (RH UPR) and the front bumper protector (LH UPR) and the front bumper protector (RH
LWR) and the front bumper protector (LH LWR) against the front bumper fascia at the left and right while fastening them with rivets. Be careful not to leave any space in between.
[Nismo 370Z]