Power Supply And Ground Circuit

POWER SUPPLY AND GROUND CIRCUIT


Diagnosis Procedure

1.CHECK FUSE
Check 10 A fuse (No. 33).
Is the inspection result normal?
YES - GO TO 2.
NO - Replace the fuse after repairing the applicable circuit.
2.CHECK SOFT TOP CONTROL UNIT POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect soft top control unit connectors.
3. Check voltage between soft top control unit harness connector and ground.





Is the measurement value normal?
YES - GO TO 3.
NO - Repair harness or connector.
3.CHECK SOFT TOP CONTROL UNIT GROUND CIRCUIT
Check continuity between soft top control unit harness connector and ground.





Does continuity exist?
YES - INSPECTION END
NO - Repair harness or connector.