Procedures

OIL PUMP


Inspection


INSPECTION AFTER INSTALLATION
1. Check the engine oil level. Inspection.
2. Start the engine, and check there is no leakage of engine oil.
3. Stop the engine and wait for 10 minutes.
4. Check the engine oil level and adjust the level. Inspection.





OIL PUMP


Inspection


INSPECTION AFTER DISASSEMBLY

Oil Pump Clearance





- Measure the clearance with feeler gauge (C).
- Clearance between oil pump outer rotor and oil pump body [position (B)]

Standard : Oil Pump

- Tip clearance between oil pump inner rotor and oil pump outer rotor [position (A)]

Standard : Oil Pump






- Measure the clearance with feeler gauge and straightedge (A).
- Side clearance between oil pump inner rotor and oil pump body
[position (C)]

Standard : Oil Pump

- Side clearance between oil pump outer rotor and oil pump body
[position (B)]

Standard : Oil Pump

- Calculate the clearance between oil pump inner rotor and oil pump body as follows:

OIL PUMP BODY INNER DIAMETER





- Measure the inner diameter of oil pump body with inside micrometer. [position (A)]

OIL PUMP INNER ROTOR OUTER DIAMETER
- Measure the outer diameter of protruded portion of oil pump inner rotor (1) with micrometer. [position (B)]

OIL PUMP INNER ROTOR TO OIL PUMP BODY CLEARANCE
- (Clearance) = (Oil pump body inner diameter) - (Oil pump inner rotor outer diameter)

Standard : Oil Pump

- If measured/calculated values are out of the standard, replace oil pump assembly.

Regulator Valve Clearance









(Clearance) = (Regulator valve hole diameter) - (Regulator valve outer diameter)

Standard : Regulator Valve

- If the calculated value is out of the standard, replace oil pump assembly.

CAUTION:
- Coat regulator valve with engine oil.
- Check that it falls smoothly into valve hole by its own weight.