Removal And Installation

BACK-UP LAMP SWITCH


Removal and Installation


REMOVAL
1. Disconnect the battery cable from the negative terminal.





2. Disconnect clip (A) from bracket (1).

White arrow indicates Vehicle front

3. Remove bracket from rear extension.
4. Disconnect back-up lamp switch connector.





5. Remove back-up lamp switch from rear extension.

White arrow indicates Vehicle front


INSTALLATION





1. Temporarily tighten back-up lamp switch onto rear extension by rotating once or twice.

CAUTION:
Remove old sealant and oil adhering to threads.
2. Apply recommended sealant to threads of back-up lamp switch as shown in the figure.
- Use Genuine Silicone RTV or an equivalent. Fluid Type Specifications.





3. Tighten back-up lamp switch to the specified torque.

White arrow indicates Vehicle front

4. For the next step and after, install in the reverse order of removal.