Removal And Installation

A/T SHIFT SELECTOR


Removal and Installation


REMOVAL
1. Shift the selector lever to "P" position.
2. Remove the control rod from the A/T shift selector assembly.
3. Shift the selector lever to "N" position.





4. Remove the knob cover (1) below the selector lever downward.
5. Pull the lock pin (2) out of the selector lever knob (3).
6. Remove the selector lever knob and the knob cover.
7. Remove the center console assembly. Exploded View.
8. Shift the selector lever to "P" position.





9. Disconnect the A/T shift selector connector (A).
10. Remove mounting bolts (Black Arrow).
11. Remove the main harness clip (B).
12. Remove the A/T shift selector assembly from the vehicle.
13. Remove the snap pin, washers, insulator, collar and pivot pin from the A/T shift selector assembly.
14. Remove the dust cover and dust cover plate from the A/T shift selector assembly.

INSTALLATION
Note the following, and install in the reverse order of removal.

CAUTION:
Apply multi-purpose grease on the pin surface (that slides after installing a collar) of the pivot pin.
- Refer to the followings when installing the selector lever knob to the A/T shift selector assembly.
1. Install the lock pin to the selector lever knob.
2. Install the knob cover to the selector lever knob.
3. Insert the shift lever knob into the shift lever until it clicks.

CAUTION:
- Install it straight, and never tap or apply any shock to install it.
- Never press selector button.