Component Function Check

TROUBLE DIAGNOSIS - SPECIFICATION VALUE


Component Function Check

1.START
Make sure that all of the following conditions are satisfied.
- Vehicle driven distance: More than 5,000 km (3,107 miles)
- Barometric pressure: 98.3 - 104.3 kPa (1.003 - 1.064 kg/cm2, 14.25 - 15.12 psi)
- Atmospheric temperature: 20 - 30�C (68 - 86�F)
- Engine coolant temperature: 75 - 95�C (167 - 203�F)
- Transmission: Warmed-up (After the engine is warmed up to normal operating temperature, drive vehicle for
5 minutes.)
- Engine speed: Idle
- GO TO 2.
2.PERFORM "SPEC" OF "DATA MONITOR" MODE
With CONSULT-III

NOTE:
Perform "SPEC" in "DATA MONITOR" mode in maximum scale display.
1. Lift up the vehicle.
2. Perform Basic Inspection.
3. Turn ignition switch ON (READY).
4. Depressed the accelerator pedal and keep it.
5. Shift the selector lever to N position with engine running.

CAUTION:
Never leave the selector lever in the N position for a long period of time. In the N position, the engine operates but electricity cannot be generated.
6. Select "B/FUEL SCHDL", "A/F ALPHA-B1" and "MAS A/F SE-B1" in "SPEC" of "DATA MONITOR" mode with CONSULT-III.
7. Make sure that monitor items are within the SP value.
8. Shift the selector lever to P position.
Is the inspection result normal?
YES - END
NO - Go to Diagnosis Procedure.