Procedures

FRONT COIL SPRING AND STRUT


Disposal

1. Set strut assembly horizontally with the piston rod fully extended.











2. Drill 2 - 3 mm (0.08 - 0.12 in) hole at the position ( ) from top as shown in the figure to release gas gradually.

CAUTION:
- Wear eye protection (safety glasses).
- Wear gloves.
- Be careful with metal chips or oil blown out by the compressed gas.

NOTE:






- Drill vertically in this direction ( ).
- Directly to the outer tube avoiding brackets.
- The gas is clear, colorless, odorless, and harmless.

(A) : 20 - 30 mm (0.79 - 1.18 in)

3. Position the drilled hole downward and drain oil by moving the piston rod several times.

CAUTION:
Dispose of drained oil according to the law and local regulations.