Coupe

FRONT SEAT


PASSENGER SIDE : Disassembly


SEATBACK

Disassembly
1. Remove the front seat assembly. Refer to Coupe.
2. Remove the headrest.
3. Remove the seatback board.
4. Remove the release handle and cover.
5. Reach inside and release the headrest holders and remove.

Assembly
Assembly is in the reverse order of disassembly.

SEAT CUSHION

Disassembly

CAUTION:
- During installation, the wire harness clips must be reinstalled in the holes they were originally in. Do not add additional clips.

NOTE:
If the vehicle has been involved in a collision, the seat must be inspected for damage. Refer to For Side and Rollover Collision.
1. Remove the front seat assembly. Refer to Coupe.
2. Remove the front seat finishers and seat outer finisher.





3. Pull up (A) on the seat cushion trim flap (1).
4. Remove two rear clips retaining the seat cushion trim flap, remove seat cushion assembly.
5. Remove the retainer on the seat cushion frame, then remove the harness connector for the seat heater.
6. After removing the seat cushion trim and pad, remove the hog rings to separate the trim from the pad and seat cushion heater unit.

Assembly
Assembly is in the reverse order of disassembly.