Removal and Installation

ACCELERATOR CONTROL SYSTEM


Removal and Installation


REMOVAL
1. Disconnect the battery negative terminal.
2. Disconnect the accelerator position sensor electrical connector.
3. Remove the three accelerator pedal nuts.
4. Remove the accelerator pedal and accelerator position sensor assembly.
- For electrical inspection of the accelerator pedal position sensor. Refer to For California (QR25DE for California), Except For California (QR25DE Except for California), P2138 (VQ35DE).

CAUTION:
- Do not disassemble the pedal assembly. Do not remove the accelerator pedal position sensor from the pedal assembly.
- Avoid impact from dropping during handling.
- Keep the pedal assembly away from water.

INSTALLATION
Installation is in the reverse order of removal.
- Align and install accelerator pedal and accelerator position sensor assembly with locating pins in locating pin holes.
- Check the accelerator pedal for smooth operation. There should be no binding or sticking when applying or releasing the accelerator pedal.





- Check that the accelerator pedal moves through the full specified distance of pedal travel.

Pedal travel (A) : 48.5 - 53.5 mm (1.91 - 2.11 in)


CAUTION:
When the harness connector of the accelerator pedal position sensor is disconnected, perform the "Accelerator pedal released position learning". Refer to For California (QR25DE for California), Except For California (QR25DE except for California), Special Repair Requirement (VQ35DE).