Service Procedure

SERVICE PROCEDURE

1. Connect CONSULT III (C-III) to the vehicle to begin the TCM reprogramming procedure.

^ If you are not familiar with the TCM reprogramming procedure, refer to CONSULT-III (C-III) Transmission Control Module (TCM) Reprogramming and Initialization general procedure.





CAUTION





2. When you get to the TCM Reprogramming screen shown in Figure 1, confirm TCM reprogramming applies as follows.

A. On your C-III screen, look at the Part Number (P/N) column (see Figure 1).

^ Write down the P/N on the Repair Order.





B. Compare the P/N you wrote down to the numbers in the Current TCM P/N column in Table A above.

^ If there is a match this bulletin applies. Continue with the reprogramming procedure.

NOTE:
If there are two lines (two reprogramming options) on your C-III screen, use the one with the message "Caution! Use ONLY with NTB10-121.

^ If there is not a match, this bulletin does not apply. Refer to ASIST for further diagnostic information.





3. If this bulletin applies and you have performed TCM reprogramming, the screen in Figure 2 displays when reprogramming is complete.

4. Make sure to erase DTCs from all systems.

NOTE:
During reprogramming, DTCs will set in several systems and must be erased.

5. Turn OFF C-III and disconnect it from the vehicle.

Install Torque Rod Service Kit





6. Replace the torque rod and the lower torque rod (numbers 1 and 8 in Figure 3).

^ Refer to the Service Manual; section EM, for removal and installation information. Use the torque rods in the Service Kit (see Parts Information).