Disassembly

INPUT SHAFT AND GEAR


Disassembly






1. Before disassembling, measure end play for 3rd, 4th, 5th, and 6th input gears.

End play standard value : Refer to End Play.

2. Remove oil channel.





3. Press out input shaft rear bearing using Tool and a puller.

Tool number : ST33052000 ( - )

4. Remove snap ring.





5. Press out 6th input gear, 6th needle bearing, 6th input gear bushing, 5th-6th synchronizer hub assembly, and 5th input gear using Tool (A) and a puller (B).

Tool number : ST33052000 ( - )

6. Remove 5th needle bearing.





7. Press out 5th input gear bushing, thrust washer, 4th input gear, 4th needle bearing, 4th input gear bushing, 3rd-4th synchronizer hub assembly, and 3rd input gear using Tool and a puller.

Tool number : ST33052000 ( - )

8. Remove 3rd needle bearing.





9. Press out input shaft front bearing using a puller.