CVT RE0F10A

P0841 TRANSMISSION FLUID PRESSURE SEN/SW A





Description
Using the engine load (throttle position), the primary pulley revolution speed, and the secondary pulley revolution speed as input signal, TCM changes the operating pressure of the primary pulley and the secondary pulley and changes the groove width of the pulley to control the gear ratio.




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE

CAUTION:
Always drive vehicle at a safe speed.

NOTE:
If "DTC CONFIRMATION PROCEDURE" has been previously performed, always turn ignition switch OFF.
Then wait at least 10 seconds before performing the next test.
1.CHECK DTC DETECTION
With CONSULT-III
1. Turn ignition switch ON.
2. Select "DATA MONITOR".
3. Start engine and maintain the following conditions for at least 12 consecutive seconds.





Is "P0841" detected?
YES - Go to CVT RE0F10A.
NO - Check intermittent incident. Refer to Intermittent Incident.




Diagnosis Procedure
1.CHECK LINE PRESSURE
Perform line pressure test. Refer to CVT RE0F10A.
Is the inspection result normal?
YES - GO TO 2.
NO - Repair or replace damaged parts. Refer to CVT RE0F10A.
2.CHECK SECONDARY PRESSURE SENSOR SYSTEM
Check secondary pressure sensor system. Refer to CVT RE0F10A.
Is the inspection result normal?
YES - GO TO 3.
NO - Repair or replace damaged parts.
3.CHECK LINE PRESSURE SOLENOID VALVE
1. Turn ignition switch OFF.
2. Disconnect CVT unit connector.
3. Check line pressure solenoid valve. Refer to CVT RE0F10A.
Is the inspection result normal?
YES - GO TO 4.
NO - Replace transaxle assembly. Refer to Exploded View.
4.CHECK SECONDARY PRESSURE SOLENOID VALVE
Check secondary pressure solenoid valve. Refer to CVT RE0F10A.
Is the inspection result normal?
YES - GO TO 5.
NO - Replace transaxle assembly. Refer to Exploded View.
5.CHECK STEP MOTOR SYSTEM
Check step motor system. Refer to CVT RE0F10A.
Is the inspection result normal?
YES - GO TO 6.
NO - Repair or replace damaged parts.
6.DETECT MALFUNCTIONING ITEMS
Check TCM connector pin terminals for damage or loose connection with harness connector.
Is the inspection result normal?
YES - Replace TCM. Refer to Exploded View.
NO - Repair or replace damaged parts.




Component Inspection (Line Pressure Solenoid Valve)
1.CHECK PRESSURE CONTROL SOLENOID VALVE A (LINE PRESSURE SOLENOID VALVE)





Check resistance between CVT unit terminal 2 and ground.





Is the inspection result normal?
YES - INSPECTION END
NO - Replace transaxle assembly. Refer to Exploded View.




Component Inspection (Secondary Pressure Solenoid Valve)
1.CHECK PRESSURE CONTROL SOLENOID VALVE B (SECONDARY PRESSURE SOLENOID VALVE)





Check resistance between CVT unit terminal 3 and ground.





Is the inspection result normal?
YES - INSPECTION END
NO - Replace transaxle assembly. Refer to Exploded View.