CVT RE0F09B

P1745 LINE PRESSURE CONTROL





Description
The line pressure solenoid valve regulates the oil pump discharge pressure to suit the driving condition in response to a signal sent from the TCM.




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE

NOTE:
If "DTC CONFIRMATION PROCEDURE" has been previously performed, always turn ignition switch OFF.
Then wait at least 10 seconds before performing the next test.
1.CHECK DTC DETECTION
With CONSULT-III
1. Turn ignition switch ON
2. Select "DATA MONITOR".
3. Make sure that output voltage of CVT fluid temperature sensor is within the range below.





Is "P1745" detected?
YES - Go to CVT RE0F09B.
NO - Check intermittent incident. Refer to Intermittent Incident.




Diagnosis Procedure
1.CHECK DTC
With CONSULT-III
1. Start engine.
2. Perform "SELF-DIAG RESULTS" mode for "TRANSMISSION".
Is "P1745" displayed?
YES - Replace TCM. Refer to Removal And Installation.
NO - Check intermittent incident. Refer to Intermittent Incident.