Manual Transmission/Transaxle: Adjustments

CONTROL LINKAGE


Adjustment


SELECT CABLE ADJUSTMENT
1. Remove the M/T finisher. Refer to Exploded View.





2. Place the M/T shift selector in the "N" position and install Tool (A) as shown

Tool number ( - ) J-48849






3. Remove the select cable eye end (1) from the select lever (2) of the control device.
4. Slide the lock (A) on the select cable eye end (1) away from the cable end.
5. Turn the select cable eye end (1) over and push the stopper (B) to release the adjustment.





6. Install the select cable eye end (1) to the select lever (2) of the control device





7. Hold the shift lever with the gap between the reverse gate stopper and the shifter base at the specified distance (A).

Distance (A) : 6.3 - 7.0 mm (0.25 - 0.28 in)






8. Push the stopper (B) into the cable eye end housing (1).
9. Slide the lock (A) over the stopper (B).
10. Check for smooth gear select operation.