LH & RH Front Anti-Pinch-Coupe
ENCODER
PASSENGER SIDE : Description
Detects condition of the power window motor RH operation and transmits to power window and door lock/unlock switch RH as pulse signal.
ENCODER
PASSENGER SIDE : Diagnosis Procedure
Regarding Wiring Diagram information, refer to Power Window System - With Left And Right Power Window Anti-Pinch.
1. CHECK ENCODER SIGNAL
1. Turn ignition switch ON.
2. Check signal between power window and door lock/unlock switch RH connector and ground with oscilloscope.
Is the inspection result normal?
YES - Check intermittent incident. Refer to Intermittent Incident.
NO - GO TO 2
2. CHECK POWER WINDOW MOTOR RH POWER SUPPLY
1. Turn ignition switch ON.
2. Check voltage between power window motor RH connector and ground.
Is the measurement value within the specification?
YES - GO TO 4
NO - GO TO 3
3. CHECK HARNESS CONTINUITY 1
1. Turn ignition switch OFF.
2. Disconnect power window and door lock/unlock switch RH and power window motor RH.
3. Check continuity between power window and door lock/unlock switch RH connector (A) and power window motor RH connector (B).
4. Check continuity between power window and door lock/unlock switch RH connector (A) and ground.
Is the inspection result normal?
YES - Replace power window and door lock/unlock switch RH. Refer to LH & RH Front Anti-Pinch-Coupe. After that, refer to Power Supply And Ground Circuit.
NO - Repair or replace harness.
4. CHECK GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect power window motor RH.
3. Check continuity between power window motor RH connector and ground.
Is the inspection result normal?
YES - GO TO 6
NO - GO TO 5
5. CHECK HARNESS CONTINUITY 2
1. Disconnect power window and door lock/unlock switch RH.
2. Check continuity between power window and door lock/unlock switch RH connector (A) and power window motor RH connector (B).
Is the inspection result normal?
YES - Replace power window and door lock/unlock switch RH. Refer to LH & RH Front Anti-Pinch-Coupe. After that, refer to Power Supply And Ground Circuit.
NO - Repair or replace harness.
6. CHECK HARNESS CONTINUITY 3
1. Disconnect power window and door lock/unlock switch RH.
2. Check continuity between power window and door lock/unlock switch RH connector (A) and power window motor RH connector (B).
3. Check continuity between power window and door lock/unlock switch RH connector (A) and ground.
Is the inspection result normal?
YES - Replace power window motor RH. Refer to Removal and Installation. After that, refer to LH & RH Front Anti-Pinch-Coupe.
NO - Repair or replace harness.