Removal And Installation

REAR DOOR GLASS


Removal and Installation


REMOVAL
1. Remove the rear door finisher. Refer to Sedan.
2. Remove the vapor barrier, being careful not to tear/damage it.
3. Temporarily reconnect the power window switch to the door harness.
4. Operate the power window switch to raise/lower the door glass until the door glass bolts (A) can be seen.





5. Remove the door glass bolts (A).
6. Remove the door glass.





7. Remove the partition sash from the glass run.
- Remove the partition sash bolt (lower) (B) and screw (upper)
(A) to remove the sash.





8. Remove the partition glass from the inside of the door in the direction as shown.

INSTALLATION
Installation is in the reverse order of removal. Reset Limit Switch after Installation: Setting of Limit Switch
- After installation inspect and adjust as necessary.