Operation CHARM: Car repair manuals for everyone.

P1715


P1715 INPUT SPEED SENSOR





Description
ECM receives input shaft revolution signal from TCM via the CAN communication line. ECM uses this signal for engine control.




DTC Logic

DTC DETECTION LOGIC

NOTE:
- If DTC P1715 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX.
- If DTC P1715 is displayed with DTC P0335, first perform the trouble diagnosis for DTC P0335. P0335.
- If DTC P1715 is displayed with DTC P0340, first perform the trouble diagnosis for DTC P0340. P0340.
- If DTC P1715 is displayed with DTC P0605, first perform the trouble diagnosis for DTC P0605. P0605.
- If DTC P1715 is displayed with DTC P0607, first perform the trouble diagnosis for DTC P0607. P0607.






DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
- GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE
1. Start engine and drive the vehicle at more than 50 km/h (31 MPH) for at least 5 seconds.

CAUTION:
Always drive vehicle at a safe speed.
2. Check 1st trip DTC.
Is 1st trip DTC detected?
YES - Go to P1715.
NO - INSPECTION END




Diagnosis Procedure
1.CHECK DTC WITH TCM
Check DTC with TCM. CONSULT-III Function (Transmission).
Is the inspection result normal?
YES - GO TO 2.
NO - Perform trouble shooting relevant to DTC indicated.
2.REPLACE TCM
Replace TCM.
- INSPECTION END