With Intelligent Key System

HOOD


HOOD ASSEMBLY : Adjustment











Check the clearance and the surface height between hood and each part by visually and touching.
If the clearance and the surface height are out of specification, adjust them according to the procedures shown below.






1. Remove hood lock and adjust the surface height of hood, front grill and front fender according to the fitting standard dimension, by rotating hood bumper rubber (body side).
2. Loosen hood hinge mounting nuts on the hood.
3. Check that hood lock primary latch is securely engaged with striker by dropping hood from approximately 200 mm (7.874 in) height or by pressing lightly on the hood.

CAUTION:
Never drop hood from a height of 300 mm (11.811 in) or more
4. Install as static closing face of hood is 94 - 490 N (9.6 - 50.0 kg, 21.1 - 110 lb).
5. After adjustment tighten lock bolts to the specified torque.

CAUTION:
- Check hood hinge rotating part for poor lubrication. If necessary, apply body grease.
- After installation, apply touch-up paint (the body color) onto the heads of hood hinge mounting bolts and nuts.