With Intelligent Key System

BACK DOOR


BACK DOOR ASSEMBLY : Adjustment











Check the clearance and the surface height between back door and each part by visually and touching.
If the clearance and the surface height are out of specification, adjust them according to the procedures shown below.





1. Loosen back door striker mounting bolts.
2. Loosen bumper rubber.
3. Adjust right and left clearances and clearances between rear bumper to the standard value specified in the table, by taping back door striker using a rubber hammer and adjusting back door striker and bumper rubber.
4. Finally tighten back door hinge, bumper rubber, and back door striker.

CAUTION:
- Check back door hinge rotating part for poor lubrication. If necessary, apply body grease.
- After installation, apply touch-up paint (the body color) onto the head of back door hinge mounting nuts.

BACK DOOR STRIKER ADJUSTMENT
Adjust back door striker so that becomes parallel with back door lock insertion direction.