Removal and Installation

COOLING FAN


Removal and Installation


REMOVAL
1. Drain engine coolant from radiator. Draining.

CAUTION:
- Perform this step engine is cold.
- Never spill engine coolant on drive belt.
2. Remove air duct (inlet) and resonator assembly. Exploded View.
3. Remove reservoir tank as follows:
a. Disconnect reservoir tank hose.





b. Release the tab (A) in the direction shown by the arrow (Black Arrow).
c. Lift up and remove the reservoir tank with the tab released.
4. Remove radiator hose (upper). Exploded View.
5. Disconnect harness connector from fan motor, and move harness to aside.
6. Remove cooling fan assembly.

CAUTION:
Be careful not to damage or scratch on radiator core when removing.

INSTALLATION
Note the following, and install in the reverse order of removal.

CAUTION:
Only use genuine parts for fan shroud mounting bolt and observe the specified torque (to prevent radiator from being damaged).

NOTE:
Cooling fan is controlled by ECM. For details, System Diagram.