Removal And Installation

WATER OUTLET


Removal and Installation


REMOVAL
1. Drain engine coolant from radiator. Draining.

CAUTION:
- Perform this step when engine is cold.
- Never spill engine coolant on drive belt.
2. Remove air duct (inlet) and resonator assembly and each air ducts. Exploded View.
3. Disconnect radiator hose (upper). Exploded View.
4. Disconnect harness connector from engine coolant temperature sensor.
5. Remove water hoses.
6. Remove heater hoses.
7. Remove water outlet.
8. Remove engine coolant temperature sensor from water outlet, if necessary.

INSTALLATION
Note the following, and install in the reverse order of removal.





- Install water control valve with making rubber ring (1) groove fit to water control valve flange (A) with the whole circumference.






1 : Water outlet

- Install water control valve (2) with the arrow (A) facing up and the frame center part (B) facing upwards.