Removal And Installation

OIL PAN (LOWER)


Removal and Installation


REMOVAL
1. Drain engine oil. Draining.
2. Remove oil pan (lower) with the following procedure:
a. Loosen mounting bolts in reverse order as shown in the figure.






Arrow Indicates : Engine front


b. Insert seal cutter [SST: KV10111100 (J-37228)] (A) between oil pan (upper) and oil pan (lower).






CAUTION:
- Be careful not to damage the mating surface.
- Never insert a screwdriver. This damages the mating surfaces.
c. Slide the seal cutter [SST: KV10111100 (J-37228)] by tapping on the side of tool with a hammer.
d. Remove oil pan (lower).

INSTALLATION
1. Install oil pan (lower) as follows:





a. Use a scraper (A) to remove old liquid gasket from mating surfaces.
- Also remove old liquid gasket from mating surface of oil pan (upper).
- Remove old liquid gasket from the bolt holes and threads.

CAUTION:
Never scratch or damage the mating surface when cleaning off old liquid gasket.










b. Apply a continuous bead of liquid gasket (A) with a tube presser (commercial service tool) as shown in the figure.

Use Genuine RTV Silicon Sealant or equivalent. Fluid Type Specifications.

CAUTION:
Attaching should be done within 5 minutes after liquid gasket application.

c. Tighten bolts in numerical order as shown in the figure.






Arrow Indicates : Engine front

2. Install oil pan drain plug.
- Refer to the figure of components for installation direction of drain plug washer. Exploded View.
3. Install in the reverse order of removal after this step.