Brake Bleeding: Service and Repair

BRAKE FLUID


Bleeding Brake System


CAUTION:
- Turn the ignition switch OFF and disconnect the ABS actuator and electric unit (control unit) connector or the battery negative terminal before performing the work.
- Monitor the fluid level in the reservoir tank while performing the air bleeding
- Always use new brake fluid for refilling. Never reuse the drained brake fluid.
- Never allow foreign matter (e.g. dust) and oils other than brake fluid to enter the reservoir tank.
1. Connect a vinyl tube to the bleeder valve of the rear right brake.
2. Fully depress the brake pedal 4 to 5 times.
3. Loosen the bleeder valve and bleed air with the brake pedal depressed, and then quickly tighten the bleeder valve.
4. Repeat steps 2 and 3 until all of the air is out of the brake line.
5. Tighten the bleeder valve to the specified torque.
- Front disc brake: Exploded View.
- Rear drum brake: Exploded View.
6. Perform steps 1 to 5 for the rear right brake to front left brake to rear left brake to and front right brake in order.
7. Check that the fluid level in the reservoir tank is within the specified range after air bleeding. Inspection.
8. Check each item of brake pedal. Adjust it if the measurement value is not the standard. Adjustments.