Refilling

BRAKE FLUID


Refilling


CAUTION:
- Turn the ignition switch OFF and disconnect the ABS actuator and electric unit (control unit) connector or the battery negative terminal before performing work.
- Never allow foreign matter (e.g. dust) and oils other than brake fluid to enter the reservoir tank.





1. Check that there is no foreign material in the reservoir tank, and refill with new brake fluid.

CAUTION:
Never reuse drained brake fluid.
2. Loosen the bleeder valve, slowly depress the brake pedal to the full stroke, and then release the pedal. Repeat this operation at intervals of 2 or 3 seconds until all brake fluid is discharged.
Then close the bleeder valve with the brake pedal depressed.
Repeat the same work on each wheel.
3. Perform the air bleeding. Service and Repair.