Component Function Check

TROUBLE DIAGNOSIS - SPECIFICATION VALUE


Component Function Check

1.START
Make sure that all of the following conditions are satisfied.
- Vehicle driven distance: More than 5,000 km (3,107 miles)
- Barometric pressure: 98.3 - 104.3 kPa (1.003 - 1.064 kg/cm2, 14.25 - 15.12 psi)
- Atmospheric temperature: 20 - 30�C (68 - 86�F)
- Engine coolant temperature: 75 - 95�C (167 - 203�F)
- Transmission: Warmed-up
- CVT models: After the engine is warmed up to normal operating temperature, drive vehicle until "FLUID
TEMP SE" (CVT fluid temperature sensor signal) indicates more than 60�C (140�F).
- M/T models: After the engine is warmed up to normal operating temperature, drive vehicle for 5 minutes.
- Electrical load: Not applied
- Rear window defogger switch, air conditioner switch, lighting switch are OFF. Steering wheel is straight ahead.
- Engine speed: Idle
- GO TO 2.
2.PERFORM "SPEC" OF "DATA MONITOR" MODE
With CONSULT-III

NOTE:
Perform "SPEC" in "DATA MONITOR" mode in maximum scale display.
1. Perform Basic Inspection.
2. Select "B/FUEL SCHDL", "A/F ALPHA-B1" and "MAS A/F SE-B1" in "SPEC" of "DATA MONITOR" mode with CONSULT-III.
3. Make sure that monitor items are within the SP value.
Is the inspection result normal?
YES - END
NO - Go to Diagnosis Procedure.