Stall Test

STALL TEST


Inspection and Judgment


INSPECTION
1. Inspect the amount of engine oil. Replenish the engine oil if necessary. Inspection.
2. After engine warms up, drive the vehicle in an urban area for approximately 10 minutes.

NOTE:
When ambient temperature is 20�C (68�F), it takes about 10 minutes for the CVT fluid to warm up to 50 to 80�C (122 to 176�F).
3. Inspect the amount of CVT fluid. Replenish if necessary.
4. Securely engage parking brake so that the tires do not turn.
5. Start the engine.
6. Apply foot brake, and shift selector lever to "D" position.
7. Gradually press down accelerator pedal while holding down the foot brake.
8. Quickly read off the stall speed, and then quickly remove your foot from accelerator pedal.

CAUTION:
Never hold down accelerator pedal for more than 5 seconds during this test.

Stall speed : Stall Speed

9. Shift selector lever to "N" position.
10. Cool down the CVT fluid.

CAUTION:
Run the engine at idle for at least 1 minute.
11. Repeat steps 7 through 10 with selector lever in "R" position.

JUDGMENT