Component Inspection

SUNLOAD SENSOR


Component Inspection

1.CHECK SUNLOAD SENSOR
1. Turn the ignition switch ON.
2. Check the input voltage from sunload sensor between A/C auto amp. harness connector and the ground. Refer to the applicable table for the normal value.











NOTE:
- When checking indoors, use a lamp of approximately 60 W. Move the lamp towards and away from the sensor to check.
- The sunload amount produced by direct sunshine in fair weather is equivalent to approximately 0.77 kW/m2 (662 kcal/m2.h).
Is the inspection result normal?
YES - INSPECTION END
NO - Replace the sunload sensor.