Special Repair Requirement

INSPECTION AND ADJUSTMENT


TCM REPLACEMENT : Special Repair Requirement


CAUTION:
Immediately after TCM is replaced or after transaxle assembly is replaced (after TCM initialization is complete), self-diagnosis result of "P1701" may be displayed. In this case, erase self-diagnosis result using CONSULT-III. After erasing self-diagnosis result, perform DTC P1701 reproduction procedure and check that malfunction is not detected. P1701.
1.CHECK AFTER WORK
1. Shift selector lever to "P" position.
2. Turn ignition switch ON.
3. Check that "P" is displayed on shift position indicator on combination meter.

NOTE:
"P" is displayed approximately 1 to 2 seconds after tuning ignition switch ON.
Does shift position indicator display "P"?
YES - INSPECTION END
NO - Check the following.
- The harness between TCM and ROM ASSY in transaxle assembly is open or shorted.
- Terminals disconnected, loose, or bent from connector housing.