Operation CHARM: Car repair manuals for everyone.

P1745


P1745 LINE PRESSURE CONTROL





Description
The line pressure solenoid valve regulates the oil pump discharge pressure to suit the driving condition in response to a signal sent from the TCM.




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE

NOTE:
Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF.
Then wait at least 10 seconds before performing the next test.
1.CHECK DTC DETECTION
With CONSULT-III
1. Turn ignition switch ON
2. Select "Data Monitor" in "TRANSMISSION".
3. Check that output voltage of CVT fluid temperature sensor is within the range below.





Is "P1745" detected?
YES - Go to P1745.
NO - Check intermittent incident. Intermittent Incident.




Diagnosis Procedure
1.CHECK DTC
With CONSULT-III
1. Start engine.
2. Perform "Self Diagnostic Results" in "TRANSMISSION".
Is "P1745" detected?
YES - Replace TCM. Exploded View.
NO - Check intermittent incident. Intermittent Incident.