Dowel Pin Alignment

CYLINDER BLOCK


Dowel Pin Alignment


REMOVAL





1. Use suitable tool to lock the drive plate and match mark (A) the drive plate before removing the bolts.

CAUTION:
Do not damage the ring gear teeth, or the signal plate teeth behind the ring gear.





2. Remove drive plate.
- Loosen the drive plate in a diagonal order.

CAUTION:
- Never place drive plate with signal plate facing down.
- When handling the signal plate, take care not to damage or scratch it.
- Handle the signal plate in a manner that prevents it from becoming magnetized.

INSTALLATION
Installation is in the reverse order of removal.





- When installing the drive plate to the crankshaft, use the match mark (A) as shown to correctly align the crankshaft side dowel pin to the drive plate side dowel pin hole.





- Install the drive plate and the reinforcement plate in the direction as shown.
- Tighten the drive plate bolts in a diagonal pattern in two steps. Disassembly And Assembly.
- Use a suitable tool to lock the drive plate.