Diagnosis Description

DIAGNOSIS SYSTEM (METER)


Diagnosis Description


SELF-DIAGNOSIS MODE
- Odo/trip meter and information display segment operation can be checked in self-diagnosis mode.
- Meters/gauges can be checked in self-diagnosis mode.

OPERATION PROCEDURE
1. Turn the ignition switch OFF.
2. While pushing the odo/trip meter switch, turn the ignition switch ON again.
3. Push the odo/trip meter switch at least 3 times within 7 seconds after the ignition switch is turned ON.
4. The unified meter control unit is turned to self-diagnosis mode.





- All the segments on the odo/trip meter illuminate.





- Dots in all segments of information display LCD (1) flash alternately.

NOTE:
If any of the segments are not displayed, replace the combination meter. Removal And Installation.
5. Push the odo/trip meter switch. Each meter/gauge should indicate as shown in the figure.